\ H.264高清编码器-HD1300-北京森润达伟成科技有限公司
 
 
 
Safety Precautions

 

  
 

We appreciate you purchasing the HD1300. Before installing the product, please read the followingcarefully.


 

 
Make sure you turn off the power before installing the HD1300.
Do not install under the direct sunlight or in dusty areas.
Make sure you use the product within the temperature and humidity specified in the specification.
Do not operate the product in presence of vibration or strong magnetic fields.
Do not put electrically conducting materials in the ventilation hole.
Do not open the top cover of the product. It may cause a failure or electric shock from the components.
To prevent the unit from overheating, make sure you keep the ventilation holes at the top least 10cm from any other object. Also allow air underneath the unit and do not obstruct vent holes.
Make sure the main power voltage is correct (220V/110V) before connecting the power adapter supplied in the box (12V DC output).
Do not obstruct ventilation holes above and below the system. Rubber feet are provided to allow air flow below the enclosure, in addition to outlet holes at the top of the enclosure.
Do not connect video source device to the HD1300-R and video display to the HD1300-T.

 

 
 
 
 
 
     
 
1.1 About this Manual

This user manual provides step-by-step instructions for installing and using HD1300. The safeguards incorporated into this unit will protect you if you observe the following procedures for installation, use, and servicing.

1.2 Overview

HD1300-T/R is a Full HD 1920 x1080 at 60 frames/second encoder/decoder designed to be used for various streaming applications where high quality video or PC output needs to be sent over an IP network at low data rates. Video resolutions from PAL and NTSC up to 1080P60 are supported as well as stereo audio. In combination with the HD1300-R decoder unit the HD1300-T can additionally stream video at extremely low latencies (delay), typically 80~120ms end-to-end. And the HD1300-T can be used to for real-time video streaming server for software decoder on the PC without HD1300-R hardware decoder. The HD1300-T/R provides a number of different video and audio interfaces together with the virtual 2-way serial cable function. Video and audio data are transmitted via a 10/100 Ethernet port or Wi-Fi. Power is supplied by the 110/240V AC to 12V DC converter supplied.

 

 
 
     
 
 
     
 
 
     
 
 
     
 
 
     
 
 
     
 
 
     
 
 
 






Video
High performance HDMI, SD/HD/3G-SDI, VGA (PC) transmission over Ethernet
H.264 encoding/decoding engine: Baseline profile level 4.2 with de-interlacing Supports both interlacing and progressive input streams
Full HD encoding up to 1920x1080p60
HD1300-T transmitter includes streaming server function
Very low encode/decode latency in 1080p60 HD: 90ms ~ 120ms
Single video stream + stereo audio
Video and PC interfaces supported by YUV & RGB
SDI/HD-SDI/3G-SDI (Level-A), HDMI v1.3 (DVI-D), VGA (PC), supported
Supports DTV Standards
·SMPTE 244, BT601 (NTSC): 525i59.94
·IEC61179-5, BT601 (PAL): 625i50
·SMPTE 296M: 720p23.98 (TX only), 720p24 (TX only), 720p25, 720p30, 720p50, 720p59.94, 720p60
·SMPTE 274M: 1080i50, 1080i59.94, 1080i60, 1080PsF23.98,1080PsF24, 1080PsF25, 1080PsF29.97, 1080PsF30, 1080p23.98, 1080p24, 1080p25, 1080p29.97, 1080p30, 1080p50, 1080p59.94, 1080p60
Supports VESA Standards
·FHD(1920x1080), WSXGA+(1680x1050), UXGA(1600x1200), HD+(1600x900), WXGA+(1440x900), SXGA+(1400x1050), WXGA(1366x768), SXGA(1280x1024), SXGA-(1280x960), WXGA(1280x800), XGA+(1152x864), XGA(1024x768), SVGA(800x600), VGA(640x480)
Wide range of video encoding and transmission rates : 100kbps ~ 30Mbps
Various encoding modes : GOP encoding mode and Slice encoding mode
Supports video up/down scaler, and video transcoder
·Video scaler: Various output video resolutions on the HD1300-R receiver ·Transcoder: Any combinations from the input videos to output video port Simultaneous video outputs supported

Audio
HDMI audio supported - Compressed or uncompressed
SD/HD/3G-SDI embedded audio
Mini-stereo phone jack in and out for analog stereo audio
Analog stereo audio: 48kHz sampling with 16 bit ADC
Supports 8kHz sampling with 16 bit ADC for reducing audio data rate
Supports G.711 for audio transmission over low bandwidth network
Back channel audio from RX to TX with 8kHz sampling and 16bit ADC
Network
Ethernet port for audio/video transmission: Ethernet LAN (10/100 BASE-TX, Cat.5e UTP cable)
One to one connection & one to many connection
Multi-Casting and simulcast modes to both the HD1300-R and software decoder on PC Various standard protocols supported : RTP/UDP/IP, Multicast, DHCP, HTTP, RTSP, RTSP streaming server or MPEG-TS streaming device
Supports Power over Ethernet (PoE) powered device (PD) supplied 12W of power (option)

Serial port for relaying bidirectional external control (RS-232/RS-422)
TTL input/output for full-duplex with the 3.3V power

User Interface
Internet Explorer/Chrome web browser for changing system configurations or firmware upgrade
IP configuration with USB not using web (version_300.00 later)

Operating conditions
0 to +40 ambient operating temperature
DC 12V input (6.6V ~ 12V)

Reliability
Reliable embedded system
System recovery utilizing dual watch-dog functions
System reset switch and factory reset operation  
 
 

点这里给我发消息